EasyManuals Logo

Telit Wireless Solutions ML865G1 Reference Guide

Telit Wireless Solutions ML865G1
1039 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 23 of 1039 2021-09-23
Not Subject to NDA
2. COMMANDS
The Telit family of wireless modules can be controlled via the serial interface using the
standard AT commands1F1F. It complies with:
1. Hayes standard AT command set, to maintain the compatibility with existing SW
programs.
2. 3GPP TS 27.007 specific AT command and GPRS specific commands.
3. 3GPP TS 27.005 specific AT commands for SMS (Short Message Service) and CBS
(Cell Broadcast Service)
Moreover, the Telit family of wireless modules also supports Telit’s proprietary AT
commands for special purposes.
The following is a description of how to use the AT commands with the Telit family of
wireless modules.
Note: The AT is an ATTENTION command and is used as a prefix to
other parameters in a string. The AT command combined with other
parameters can be set up in the communications package or typed in
manually as a command line instruction combined with other
parameters can be set up in the communications package or typed in
manually as a command line instruction.
Definitions
The following syntactic definitions apply:
<CR> Carriage return character, is the command line and terminator character of the
result code, whose value, in decimal ASCII between 0 and 255, is specified within
the parameter S3. The default value is 13.
<LF> Linefeed character, is the character recognized as line feed character. Its value, in
decimal ASCII between 0 and 255, is specified within parameter S4. The default
value is 10. The line feed character is output after the carriage return character if
detailed result codes are used (V1 option used) otherwise, if numeric format result
codes are used (V0 option used) it will not appear in the result codes.
<...> Name enclosed in angle brackets is a syntactic element. They are not displayed on
the command line.
[...] The optional sub parameter of a command or an optional part of the TA information
response is enclosed in square brackets. The brackets themselves are not

Table of Contents

Other manuals for Telit Wireless Solutions ML865G1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions ML865G1 and is the answer not in the manual?

Telit Wireless Solutions ML865G1 Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelML865G1
CategoryWireless modules
LanguageEnglish

Related product manuals