ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 515 of 1039 2021-09-23
Warning: the "Common profile" information contained in the
"Setting saved" field of the table, placed above the command
syntax, must be replaced with "NO".
AT#DVI?
Read command reports last setting, in the format:
#DVI: <mode>,<dviport>,<clockmode>
AT#DVI=?
Test command reports the range of supported values for parameters
<mode>,<dviport> and <clockmode>.
Modules Supporting the command
Configure DVI as master using the DVI Port #2 (the only available)
AT#DVI=1,2,1
OK
To Next Page
Loading...
Need help?
General
