Telit Wireless Solutions ML865G1 Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 549 of 1039 2021-09-23
Not Subject to NDA
0÷3FF
:
addressing range extended to 10 bit
<lenwr>
integer
N/A
number of data to write.
Value:
0÷254
:
number of data to write.
<lenrd>
integer
N/A
number of data to read.
Value:
0÷254
:
number of data to read.
Additional info:
After entering the command, and if <lenwr> > 0, the module returns
the prompt ">" and waits for the data to send. To complete the
operation enter Ctrl-Z char (0x1A hex); to exit without writing the
message enter ESC char (0x1B hex).
Data must be written in hexadecimal form without 0x.
If data are successfully sent, the response is OK, otherwise an error
code is reported.
AT#I2CCF=?
Test command returns the range of available values for parameters
<sdaPin>, <sclPin>, <deviceId>, <lenwr>, <lenrd>.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English