Telit Wireless Solutions ML865G1 Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 636 of 1039 2021-09-23
Not Subject to NDA
<userId>
string
-
user identifier, used only if the context
requires it
<pwd>
string
-
password, used only if the context requires
it
Additional info:
Meaning of the parameters returned by the command.
Name
Type
Default
Description
<ipAddr>
string
-
ip address ipv4 or ipv6
<ipAddrV4>
string
-
ip address ipv4 (if v4 PDP context
activated)
<ipAddrV6>
string
-
ip address ipv6 (if v6 PDP context
activated)
Context activation/deactivation returns ERROR if there is not any
socket associated to it, see #SCFG.
In LTE network, default PDP context (<cid>=1) is activated by
piggybacking on LTE attach procedure and maintained until
detached from network. This command with <cid>=1 is just binding
or unbinding application to the default PDP context.
If the unsolicited result code for obtaining IP address was enabled
(urcmode value) using #SGACTCFG command, on start up and due
to USB enumeration timing the unsolicited may not appear, user
should manually use +CGPADDR command to see the IP address.
#SCFG=x,0 will close all unclosed AT#SD sockets on <cid>=x.
AT#SGACT?
Read command returns the state of all the contexts that have been defined
in the format:

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English