Telit Wireless Solutions ML865G1 Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 644 of 1039 2021-09-23
Not Subject to NDA
0
:
dummy value
<unused>
mixed
N/A
unused parameter
Value:
0
:
dummy value
<abortAttemptEnable>=1 takes effect on successive PDP context
activation attempt through #SGACT command. While waiting for
AT#SGACT=<cid>,1 response, it is possible to abort attempt by sending a
byte and get back AT interface control (NO CARRIER indication).
If we receive delayed CTXT ACTIVATION ACCEPT after abort, network will
be automatically informed of our aborted attempt through relative
protocol messages (SM STATUS) and will also close on its side.
Otherwise, if no ACCEPT is received after abort, network will be informed
later of our PDP state through other protocol messages (routing area
update for instance).
The command is not effective while the context is already open.
AT#SGACTCFGEXT?
Read command reports the state of all the five contexts, in the format:
#SGACTCFGEXT: <cid
1
>,< abortAttemptEnable
1
>,0,0,0<CR><LF>
...
#SGACTCFGEXT: <cid
n
>,< abortAttemptEnable
n
>,0,0,0<CR><LF>
AT#SGACTCFGEXT=?
Test command reports supported range of values for all parameters.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English