Telit Wireless Solutions ML865G1 Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 655 of 1039 2021-09-23
Not Subject to NDA
<noCarrierMode>
integer
0
select the NO CARRIER
message format received
when the socket is closed.
Values:
0
:
no additional information is attached to
NO CARRIER message
1
:
NO CARRIER: <connId> message
2
:
NO CARRIER: <connId>, <cause>
message. Refer to Additional info section
Additional info:
<noCarrierMode>=2 selects the following NO CARRIER message format:
NO CARRIER: <connId>, <cause>
Name
Type
Default
Description
<cause>
integer
-
is the socket disconnection cause.
Refer to #SLASTCLOSURE command to
know its values and meanings.
Is necessary to avoid overlapping of the two methods. Enabling new
method, the old method for transmission timer (#SCFG) is automatically
disabled to avoid overlapping.
Check if new data have been received from serial port is done with a
granularity directly related to <txTo> parameter which is set by #SCFG
command. The maximum period is 1 sec.
Like #SLASTCLOSURE, in case of subsequent consecutive closure causes
received, the original disconnection cause indicated.
In the case of command mode connection and remote closure with
subsequent inactivity timeout closure without retrieval of all available data

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English