Telit Wireless Solutions ML865G1 Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 779 of 1039 2021-09-23
Not Subject to NDA
<cid>
intege
r
-
PDP context identifier. See +CGDCONT
command.
<pkt_size>
intege
r
0
size for data sending (#HTTPSND) or
receiving (#HTTPRCV).
Values:
0
:
select automatically value 300
1÷1500
:
send or receive size in bytes
<unused1>
intege
r
-
parameter for future use. Must be set to 0.
<unused2>
intege
r
-
parameter for future use. Must be set to 0.
A special form of the set command, AT#HTTPCFG=<prof_id>, causes the
values for profile number <prof_id> to reset to default values.
Only one profile can use the SSL encryption.
AT#HTTPCFG?
Read command returns the current settings for each defined profile in the format:
#HTTPCFG:<prof_id>,<server_address>,<server_port>,<auth_type>,<username>,
<password>,<ssl_enabled>,<timeout>,<cid>,<pkt_size>,0,0<CR><LF>[<CR><LF>
#HTTPCFG:<prof_id>,<server_address>,<server_port>,<auth_type>,<username>,
<password>,<ssl_enabled>,<timeout>,<cid>,<pkt_size>,0,0]<CR><LF>[...]]
AT#HTTPCFG=?
Test command returns the supported range of parameters <prof_id>,
<server_port>, <auth_type>, <ssl_enabled>, <timeout>,
<cid>,<pkt_size>,<unused1>,<unused2>, and the maximum length of
<server_address>, <username> and <password> parameters in the format:

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English