Telit Wireless Solutions ML865G1 Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 845 of 1039 2021-09-23
Not Subject to NDA
HMAN0
:
default value
<hostModel>
string
HMOD0
contains a string, between
double quotes, with the host
model identifier.
Value:
HMOD0
:
default value
<hostSwVersion>
string
HSW0
contains a string, between
double quotes, with the host
software version identifier.
Value:
HSW0
:
default value
The odis setting requires all the odis values to be set each time the
command is issued, therefore, to change only one odis parameters it is
recommended to read all the values first, and then compose the command
input string accordingly.
Since the odis items are 4, it is quite unlikely but possible that some the
storing of some of them fails. In this case, the new values, where
succeeded, are kept. An advice is that, in case of storing failure, the
+ODIS? command is used to verify what are the odis items changed, if any.
Starting from AT&T Specification Reference: 13340 v20.3, <CDR-DVM-
1600>, the Odis Instance should be added as a first parameter to the +ODIS
AT command. This will result in having a +ODIS command no longer
compatible with previous command versions (i.e.: until specification
Reference 13340 v20.2).
AT+ODIS?
Read command reports the current Odis values in the format:
+ODIS: 0,<hostManufacturer0>,<hostModel0>,<hostSwVersion0>
+ODIS: 1,<hostManufacturer1>,<hostModel1>,<hostSwVersion1>

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English