Telit Wireless Solutions ML865G1 Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 945 of 1039 2021-09-23
Not Subject to NDA
Else, the command fails. This option is
valid only if client is in active state.
2
:
Awake state: Required only to go to asleep
state. Sleeping client will send a keep-alive
packet to the gateway, receive all the
buffered Publish packets sent by the
gateway and will again go to asleep state.
This option is valid only if client is in asleep
state.
<duration>
integer
-
Sets the period of clients sleep
in seconds. After expiry of this
duration, the client sends a
keep-alive packet to the
gateway, receives all the
buffered Publish packet sent by
the gateway and again goes to
asleep state. This parameter is
mandatory if user is setting
value of <state> parameter to 1.
AT#MQSNSTATE?
Read command returns the state of all initialised MQTT-SN clients in the
format
#MQSNSTATE: <instanceNumber>,<state>[,<duration>]
AT#MQSNSTATE=?
Test command reports the available range of values for parameters.

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English