Appendix – Looking ‘Under the Hood’
8 - 36 Gettings Started with the MSP430 - Using Energia (Arduino)
Sidebar Cont’d - Where is F_CPU defined?
We searched high & low and couldn’t find it. Finally, after reviewing a number of threads in the
Energia forum, we found that it is specified in boards.txt. This is the file used by the debugger
to specifiy which board (i.e. target) you want to work with. You can see the list from the
ToolsBoard menu.
C:\TI\energia-0101E0010\hardware\msp430\boards.txt
To Next Page
Loading...
