Thermo Scientific Micro-Tech 9101 - Page 192

B-20 Micro-Tech 9101/9201 Reference Manual, Rev J Thermo Fisher Scientific
Parameter
Selection
Description
Run belt empty, then press
START
Run quantity of material over
scale.
CONTINUE
X.XX Tons
DONE, ABORT
X.XX Tph
press DONE to end
X.XX Tons
YES, NO
Ref. weight known?
XXX.XX Tons
EDIT, ABORT
Enter reference
weight _____ Tons
MAT’L CAL. COMP.
YES, NO, ADV
XXXX = Error %, Diff. Total
XXXX
Change span ?
SPAN # CHANGED RUN, MENU, FACTOR* *This option is only
available if a simulated
Auto Span calibration has
been completed
beforehand.
New span #
Old span #
MAT’L CALIBRATION
RCAL*, WTS*, CHAIN*
*Each option is only
available if a Auto Span
calibration has been
completed beforehand with
that simulated method.
Automatic correction
to Material Factors
XXXX Matl FACTOR
YES, NO, ADV
XXXX = R-CAL, WTS,
CHAINS
ZZZZ = New factor, Old
factor
ZZZZ %
Change factor?
XXXX Matl FACTOR
RUN, MENU, FACTOR
XXXX = R-CAL, WTS,
CHAINS
Old factor %
New factor %
MAT’L CALIBRATION
YES, NO
Add reference weight to totals?