Thermo Scientific Micro-Tech 9101 - Page 198

B-26 Micro-Tech 9101/9201 Reference Manual, Rev J Thermo Fisher Scientific
No.
Parameter
Selection
Description
6
Total test weight on
scale
0.000* lbs
Stamped weight of calibration weight(s).
Stamped at each handle end.
*Maximum is load cell size multiplied by
number of load cells.
7 Weight Cal constant Calculated (or factored) accumulated weight
at end of simulated static weight calibration
8
Calibration interval
0 days (0 - 365)
The system can be programmed to prompt
you when the next calibration is due. If you
do not want this option, confirm the default 0
days interval; otherwise enter the number of
days.
If a non-zero value is entered, an alarm
appears after the time is elapsed. The alarm
can only be cleared after a calibration check
is executed.
9
Calibration date
Last
Next
This scroll displays the date of the last
calibration and the expected date of the next
one, based on the entry in the previous
screen.
10
Material FACTOR
R-CAL
0.00% (-99.99 - 99.99)
Correction factor for Rcal calibration when
span is derived from other calibration
standard
Material FACTOR
CHAINS
0.00% (-99.99 - 99.99) Correction factor for Chain calibration when
span is derived from other calibration
standard
Material FACTOR
WEIGHT
0.00% (-99.99 - 99.99)
Correction factor for Static Weights
calibration when span is derived from other
calibration standard
11
Nr. of test duration
1, 2
Either a full length (1) or a shorter time test
duration (2)
12
Establish test
duration
ACQ, MANUAL
ACQUIRE TEST
DUR
Choose belt length
measurement
method.
FULL, PARTIAL
Ent. len. of one belt
revolution.
(1 - 30,000 ft)
Measured length of entire belt length
Ent. len. between two
marks on belt.
(1 - 10,000 ft)
Enter the number of
belt revolutions to be
timed
(1 - 100 rev)
Required belt revolutions to achieve
minimum test time