33
BASIC OPERATIONS
BASIC OPERATIONS
PREPARATION BEFORE MEASUREMENT
TURNING ON THE INSTRUMENT
1 Make sure the power cable is connected properly.
For the details of the connection, refer to “CONNECTING POWER CABLE” on page 28.
2 Turn on the SWITCH.
3 The title screen and measurement screen are displayed and the confirmation message of
setting of safety stopper is displayed in a few seconds.
4 Tap either the button or button, return to the Measurement screen.
NOTES
Do not put the patient's face on the chinrest until the power is on.
NOTES
• Refer to 37 Page for SETTING THE SAFETY STOPPER.
• If "YES" is tapped, the confirmation message of setting of safety
stopper is displayed upon power ON from next time.
• If "NO" is tapped, the confirmation message of setting of safety
stopper is not displayed upon power ON from next time.
/3
/3
/3
/3
/1
/1
/1
/1
Please be sure to perform setting of
safety stopper before measuring, for
patient safety.
Display this message at power on
also from the next time?
YES NO
To Next Page
Loading...
