Topcon CT-1P - Before Requesting Service; Trouble-Shooting Operations; Message List

111
BEFORE REQUESTING SERVICE
BEFORE REQUESTING SERVICE
TROUBLE-SHOOTING OPERATIONS
MESSAGE LIST
"ERROR" Displayed when the measurement is an error.
"OVER" Displayed when the measurement is over.
"Finished" Displayed when normal measurements are completed for the set
measurement count.
"CLEAN THE
MEASURING WINDOW
GLASS"
Displayed when a blot is detected on the measuring window during
TONO measurement. Clean the measuring window glass by refer-
ring to "CLEANING THE MEASURING WINDOW GLASS" on
page 103.
"CLEAN INSIDE
NOZZLE/GLASS"
Displayed when a blot is detected on the measuring window during
TONO measurement. Clean the measuring nozzle and the glass
inside the measuring nozzle by referring to "CLEANING THE NOZ-
ZLE AND THE GLASS INSIDE THE MEASURING NOZZLE" on
page 104.
"Close printer cover" The printer cover is open. Close the cover until it clicks.
"Paper end" Printer paper is used up. Supply printer paper.
"Fatal Error!" Displayed when the printer unit does not operate normally, such as
the cutter does not work. Call the serviceman.
"Patient ID is required.
Please set patient ID."
Displayed when the output operation is requested when the setting
"Required patient ID" is ON but the patient ID is not inputted. Enter
the patient ID and then request the output operation.
"Operator ID is required.
Please set Operator ID."
Displayed when the output operation is requested when the setting
"Operator ID request" is ON but the operator ID is not inputted.
Enter the operator ID and then request the output operation.
"Please set the limit within
0 mm to 30 mm."
Displayed on the Safety Stopper screen, when the z-axis position
is outside the 0-30mm.
"LAN hostname error" Failed to resolve the host name of the destination (to be connected
with the shared folder). Confirm the inputted host name or DNS
server address.
"LAN mount error" Failed to connect to the shared folder.
Confirm the address, folder name, user name and password of the
destination (to be connected with the share folder).
"Permission error of folder" Failed to create the file.
Confirm that write permission to the share folder is set correctly.
"LAN write error" Failed to write to the file.
Check the free space capacity at the save location.
"LAN stop error" Failed to reset the LAN connection. Confirm that the LAN cable
connection and the LAN setting are in the correct way.