Topcon CT-1P - Setting the Required Patient ID; Setting the Device ID Number

73
SETTING FUNCTIONS ON THE SETUP SCREEN
SETTING THE REQUIRED PATIENT ID
It is possible to set whether or not to require the patient ID. Before shipment, the default set-
ting is "OFF."
1 Tap the button of the set item display "Required patient ID" in the "Initial"
menu.
2 Tap the button and select "ON" or "OFF."
3 The setting is complete.
SETTING THE DEVICE ID NUMBER
The device ID number can be set. Before shipment, the default setting is "1".
1 Tap the button of the set item display "Device ID number " in the "Initial"
menu.
2 Enter the number with the ten-key display of the button.
3 The setting is complete by tapping the button.
NOTES
When outputting, patient ID is not inputted, a warning is displayed
if the setting is ON.
Current Condition
OFF
ON
Return
Initial
Print
Comm
LAN
Special
Operator ID
2/5
Patient No. reset
Show patient ID
Required patient ID
Device ID number
OFF
OFF
ON
1
Show Device ID number
Stand by mode
Auto power save
RIGHT
OFF
10 min
Touch Measure
OFF
Options
Current Condition
Options
Return
Initial
Print
Comm
LAN
Special
BS
7
4
1
0
8
5
2
9
6
3
AC
OK CANCEL
Operator ID
2/5
Patient No. reset
Show patient ID
Required patient ID
Device ID number
OFF
OFF
ON
1
Show Device ID number
Stand by mode
Auto power save
RIGHT
OFF
10 min
Touch Measure
OFF
OK