Topcon CT-1P - Manual Measurement Mode; Setting the Manual Mode; Setting the Measuring Range

46
BASIC OPERATIONS
MANUAL MEASUREMENT MODE
SETTING THE MANUAL MODE
1 Check that the MEASUREMENT screen is on. If the button is "M," the
mode is Manual mode.
2 If "A" (Auto mode) is displayed, tap it and change to "M".
SETTING THE MEASURING RANGE
In this instrument, the measuring range can be switched in 2 steps between "1-30" and "1-60."
Normally, "1-30" is used, but if the patient's ocular pressure is high, switch it to "1-60." The
default setting is "1-30" upon power on.
1 Check the measurement screen.
2 Tap the button of the control panel and set the measuring range.
NOTES
• Adjust the height of the instrument table so that the patient can
sit comfortably. Otherwise, correct measurement values may
not be obtained.
• Do not perform measurement if the patient stops breathing or is
nervous. Otherwise, correct measurement values may not be
obtained.
• If the machine is moved before measurement values are dis-
played, it may cause incorrect measurement results.
AUTO/MANUAL
PatientID
PatientID








1
1
T
OPCON
T
ARO
U
TOPCONTAROU
PatientID
PatientID








1
1
T
OPCON
T
ARO
U
TOPCONTAROU
30/60