Topcon CT-1P - Setting the Number of Continuous Measurements (Tono); Setting the Number of Continuous Measurements (Pacho)

76
SETTING FUNCTIONS ON THE SETUP SCREEN
SETTING THE NUMBER OF CONTINUOUS MEASUREMENTS (TONO)
The number of continuous measurements (TONO) can be set. Before shipment, the default
setting is "3."
1 Tap the button of the set item display "Cont. cycle(TONO)" in the "Initial"
menu.
2 Tap the button and enter the number with the ten-key display.
3 The setting is complete by tapping the button.
SETTING THE NUMBER OF CONTINUOUS MEASUREMENTS (PACHO)
The number of continuous measurements (PACHO) can be set. Before shipment, the default
setting is "3."
1 Tap the button of the set item display "Cont. cycle(PACHO)" in the "Ini-
tial" menu.
2 Tap the button and enter the number with the ten-key display.
3 The setting is complete by tapping the button.
NOTES
The input number range is 2-10.
NOTES
• The input number range is 2-10.
•Only in CT-1P.
Current Condition
3/5
Return
Initial
Print
Comm
LAN
Special
BS
7
4
1
0
8
5
2
9
6
3
AC
OK CANCEL
Operator ID
Cont. cycle(TONO)
Cont. cycle(PACHO)
Add Measure
3
3
1
2011 1101Date/Time
Init. measure mode
Tono display Unit
Pacho display Unit
T/P
mmHg
mm
IncludingLow Credibility Measure
Options
OK
Current Condition
Return
Initial
Print
Comm
LAN
Special
BS
7
4
1
0
8
5
2
9
6
3
AC
OK CANCEL
Operator ID
3/5
Cont. cycle(TONO)
Cont. cycle(PACHO)
Add Measure
3
3
1
2011 1101Date/Time
Init. measure mode
Tono display Unit
Pacho display Unit
T/P
mmHg
mm
IncludingLow Credibility Measure
Options
OK