Topcon CT-1P - Displaying the Device ID Number; Setting the Waiting Position after Measurement

74
SETTING FUNCTIONS ON THE SETUP SCREEN
DISPLAYING THE DEVICE ID NUMBER
It is possible to set whether or not to display the device ID number. Before shipment, the
default setting is "OFF."
1 Tap the button of the set item display "Show Device ID number" in the
"Initial" menu.
2 Tap the button and select "ON (display)" or "OFF (do not display)."
3 The setting is complete.
SETTING THE WAITING POSITION AFTER MEASUREMENT
It is possible to set the waiting position of the measuring head after finishing each measure-
ment. Before shipment, the default setting is "RIGHT" (initial position for measuring right eye).
1 Tap the button of the set item display "Stand by mode" in "Initial" menu.
2 Tap the button and select the desired waiting position:
"RIGHT": Waiting at the initial position for right eye measurement
"LEFT": Waiting at the initial position for left eye measurement
"LAST": Waiting at the last position of the measured eye
3 The setting is complete.
Current Condition
OFF
ON
Return
Initial
Print
Comm
LAN
Special
Operator ID
2/5
Patient No. reset
Show patient ID
Required patient ID
Device ID number
OFF
OFF
ON
1
Show Device ID number
Stand by mode
Auto power save
RIGHT
OFF
10 min
Touch Measure
OFF
Options
Current Condition
RIGHT
LEFT
LAST
Return
Initial
Print
Comm
LAN
Special
Operator ID
2/5
Patient No. reset
Show patient ID
Required patient ID
Device ID number
OFF
OFF
ON
1
Show Device ID number
Stand by mode
Auto power save
RIGHT
OFF
10 min
Touch Measure
OFF
Options