Topcon CT-1P - Setting the Date and Time (Date;Time); Setting the Initial Measurement Mode

78
SETTING FUNCTIONS ON THE SETUP SCREEN
SETTING THE DATE AND TIME (DATE/TIME)
Date and time can be set. Before shipment, the default setting is "Installation date/time".
1 Tap the button of the set item display "Date/Time" in the "Initial" menu.
The input screen is displayed.
2 Tap and select the item to be set (year, month, day, hour, minute, second), and enter the
number with the ten-key display shown above.
3 The setting is completed by tapping the button.
SETTING THE INITIAL MEASUREMENT MODE
The initial measurement mode, at power on, can be changed. Before shipment, the default
setting is "T/P."
1 Tap the button of the set item display "Init. measure mode" in the "Initial"
menu.
2 Tap the button and select T/P or TONO.
3 The setting is complete.
Current Condition
Return
Initial
Print
Comm
LAN
Special
BS
7
Y 11 11
M D
H M S
4
1
0
8
5
2
9
6
3
AC
OK CANCEL
11 01
07 37 51
Operator ID
3/5
Cont. cycle(TONO)
Cont. cycle(PACHO)
Add Measure
3
3
1
2011 1101
Date/Time
Init. measure mode
Tono display Unit
Pacho display Unit
T/P
mmHg
mm
IncludingLow Credibility Measure
OK
Current Condition
TONO
T/P
Return
Initial
Print
Comm
LAN
Special
Operator ID
3/5
Cont. cycle(TONO)
Cont. cycle(PACHO)
Add Measure
3
3
1
2011 1101
Date/Time
Init. measure mode
Tono display Unit
Pacho display Unit
T/P
mmHg
mm
IncludingLow Credibility Measure
Options