EasyManua.ls Logo

Topcon OPUS A6G2 - Page 434

Topcon OPUS A6G2
800 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
434
OPUS Projektor Manual
Object Reference
This event is triggered as soon as the device enters the On (normal operation) state but
only if it was in low power or sleep mode before (switch ignition on). If the device just did a
cold boot, this event is not triggered.
Allowed actions:
·
Execute Script
·
Set Value
OnLowPower
This event is triggered as soon as the ignition is switched off and the device enters low
power mode.
Allowed actions:
·
Execute Script
·
Set Value
OnSleep
This event is triggered as soon as the device awakes from sleep mode (not before going
into sleep).
Allowed actions:
·
Execute Script
·
Set Value
OnPageInit
This event is triggered as soon as a new page is loaded.
Allowed actions:
·
Execute Script
OnPageInitFinished
This event is triggered as soon as the loading of the new page is finished.
Allowed actions:
·
Execute Script
OnPageExit
This event is triggered as soon as a page is left.
Allowed actions:
·
Execute Script
OnPageRepeat
This event is periodically triggered when the page is loaded.
Allowed actions:
·
Execute Script
OnPress
This event is triggered either if an object on screen is pressed via touchscreen or encoder
or if a softkey is pressed.
Allowed actions:
·
Execute Script
·
Jump To Page
·
Set Value (Not for Frame object)
·
Next Softkey Level (Softkey object only)
·
Previous Softkey Level (Softkey object only)

Table of Contents