Topcon OPUS A6G2 - General Objects; Page Object; Alarms

443
OPUS Projektor Manual
Object Reference
This action is currently not supported and has no effect at runtime.
6.3
General Objects
6.3.1
Page Object
The page object is the root object for designing a page.
Only Frame objects can be added to a page.
A page can also be used as video page. See properties below.
The page has a limited set of properties. For a description of the general properties see
here .
Page Specific Properties
Connect All Softkey Frames
When changing Softkey levels it is possible to switch a level of each Softkey Frame
separately or to connect all Softkey Frames. When the Softkey Frames are connected,
changing the level of one Softkey Frame will also change the level of the other.
Default value: Enabled
Possible values: Enabled or Disabled
For Video Properties please see here .
Events
The following events can be configured for the page:
· OnPageInit
· OnPageExit
· OnPageRepeat
See here for the descriptions of all event and possible actions that can be assigned.
6.3.2
Alarms
For a description of the alarm settings in project properties and for how to create an alarm
see here .
Alarms share some properties with other objects. For a description of the common properties
see here .
Alarm Specific Properties
Alarm Number
This property shows the alarm number of the alarm as defined when creating the alarm.
This number can be changed but needs to stay unique.
Default value: Alarm number specified when creating the alarm
Possible values: 1 ... 32767 (but needs to be a unique alarm number)
Alarm Type Name
The type of the alarm is defined when creating it. It can not be changed after the alarm was
created.
Default value: Alarm type chosen when creating the alarm
Possible values: Not editable
415
508
430
568
415