466
OPUS Projektor Manual
Object Reference
Will be automatically set when adding a released state object to the button (see above).
Can't be edited by hand.
Pressed Image (Theme dependent)
Alternatively to putting one or two Picture Graphic objects into the button, this property can
be used to add an image to the button. The image set in this property will be used as the
pressed image. If no image is set for the Released Image property but for the Pressed
Image property, the button will only show an image when it is pressed. Both properties
should be set with an image.
Released Image (Theme dependent)
Alternatively to putting one or two Picture Graphic objects into the button, this property can
be used to add an image to the button. The image set in this property will be used as the
released image. If no image is set for the Pressed Image property but for the Released
Image property, the button will only show an image when it is released. Both properties
should be set with an image.
Events
The following events can be configured for the button object:
·
OnPress
·
OnRelease
·
OnLongPress
·
OnLongRelease
·
OnDblClick
·
OnOpenForInput
·
OnEnabledWithFocus
·
OnEnabledWithoutFocus
·
OnValueChange
·
OnCancel
See here for the descriptions of all event and possible actions that can be assigned.
6.4.4
Container
Tutorial video about the container object
https://www.youtube.com/watch?v=6ttjYv3fIRc
The container object is only a "container" for other objects. It is not visible at runtime.
A container can be used to group other objects and add a deeper hierarchy in the project
tree.
The Visibility property can be used to make all objects inside the container visible or
invisible with just one command and no need to assign visibility properties to each object in
the container. Also, moving a set of objects is easier when they are in a container.
430
588
To Next Page
Loading...