165
OPUS Projektor Manual
Variables
This describes the interface PClient will use to communicate with the process. By
default this is the same as the program's name but located in folder "tmp".
If you should not know what a socket is: Consider it a kind of file which is used to
exchange variable values.
As with all the description properties this mainly exists for your convenience
(especially when re-opening your GUI definition after a longer period of time).
So take the time to add a sensible description of what this process should do and why
it was created. Then it could be helpful for others looking into your GUI definition, e.g.
our support team.
4.2
Variable Menus
This is a page describing variable creation and maintenance.
It is based on the concepts described in general variable approach and also uses settings
explained in variable owner configuration .
Definition of Data Types
Data types can be created and maintained in the "Data type definitions" dialog.
Open Data Types Definitions Dialog
1. Open menu "Communication".
2. Select "Options"
3. Choose
Use Data Type Definitions Dialog
154
160
To Next Page
Loading...