616
OPUS Projektor Manual
Simulations
Just double-click the value in the table that shall be changed and enter the new value.
Sending an initialization list
Select an initialization list then click the Send Now button on the lower right of the view.
The variable simulation will send requests for all variables in the list with the configured
values to the PClient.
9.3.6
Variable Simulation FAQ
Why is the current value of a variable not updated after changing the
value in the simulation?
The reason is a possible wrong setting of the "Overwrite Owner's Value" checkbox in the
value operations view. See here for a detailed description.
Why can't I see anything in the variable tree?
If the variable tree is completely empty, the variable simulation has probably lost connection
to PClient (see status bar messages).
Make sure that PClient runs. The variable simulation will automatically try to reconnect to
the PClient.
The variable tree shows only the owners but no variables
This can be caused by:
·
A filter text was set but no matching variable was found
·
Show Favorites Only was selected but no variable was marked as favorite
·
Hide Pre-Defined Variables was selected but no user defined variables are present
in the project
·
A combination of the three points above
Why is the checkbox to start the PClient simulation disabled?
This checkbox is disabled if the connection settings were configured to connect to a
running PClient via ethernet in the Simulation Settings .
610
596
To Next Page
Loading...