749
OPUS Projektor Manual
How To
When returning from Low Power or Sleep mode, the device will continue where it was
instead of starting freshly.
If disconnecting clamp 15 is not possible, consider using the variable
@PWR_CurrentPowerMode.
You can shut down by setting it to 0x4A17.
12.8
How to use the digital outputs
The digital outputs that are available on some of the variants of our displays are open-drain
outputs.
This means that they are not actively pushing any voltage.
Instead, they connect an external power source to ground, closing the circuit and thus enabling
the external element.
To Next Page
Loading...