Topcon OPUS A6G2 - Manual Update of the Service Ramdisk

785
OPUS Projektor Manual
OPUS devices update manual
phys_addr=0x80100000
++Searching for BBT table in the flash ...
Found version 1 Bbt0 at block 8191 (0x3ffe0000)
Total bad blocks: 0
hardware reset by POR
Clock input is 24 MHz
Hardware: OPUS A3 standard full
Total RAM size: 268435456 byte (256MB)
Chip is working in consumer mode
Using display configuration "Seiko WQVGA"
RedBoot(tm) bootstrap and debug environment [ROMRAM]
Non-certified release, version OPUS A3 1.3.2-3 - built
15:12:00, Mar 25 2015
Platform: OPUS A3 (i.MX35) PASS 2.0 [x32 DDR2]
Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc.
Copyright (C) 2003, 2004, 2005, 2006 eCosCentric Limited
RAM: 0x00000000-0x07f00000, [0x00096618-0x07ed1000] available
FLASH: 0x00000000 - 0x40000000, 8192 blocks of 0x00020000 bytes
each.
== Executing boot script in 0.100 seconds - enter ^C to abort
^C
RedBoot> ^C STEP 5
RedBoot> ^C
RedBoot>
RedBoot> romupdate STEP 6
Updating ROM in NAND flash
RedBoot>
14.4.3.2
Manual update of the service ramdisk
If the update still won’t start, you also have to update the service ramdisk.
For this, have the file zImage.service ready on your computer and follow the same steps as
for the boot loader file up to step 3, where you send the file zimage.service.
The loading of this file takes about 15 to 25 minutes; please be patient and wait until
it is finished!
After you’ve returned to the boot prompt, install the service ramdisk by entering the command
fis create service.
The line
"An image named ‘service’ exists – continue (y/n)?"
is displayed, confirm by entering “y”. After that power off the device and install the correct OS
again using the method described in chapter 3.