Topcon OPUS A6G2 - ISOBUS Application

576
OPUS Projektor Manual
Functionalities
Apply "Default Day Theme" to Project
When this button is pressed, ALL existing objects in the project that have Day/Night Mode
enabled will have the current default Day Theme set as their day theme.
Note: This overwrites all theme properties of all existing objects!
Default Night Theme
This selection will be the default Night Theme for newly created objects
Apply "Default Night Theme" to Project
When this button is pressed, ALL existing objects in the project that have Day/Night Mode
enabled will have the current default Night Theme set as their night theme.
Note: This overwrites all theme properties of all existing objects!
Apply settings to Project
When this button is pressed, all three "Apply to Project" actions described above are
executed.
8.3
ISOBUS Application
For the devices OPUS A6 Generation 2, OPUS A8, B3, X18 and X40, a special ISOBUS
application can be created.
This type of application can only be installed on devices with an OPUS ISOBUS solution
license.
For the OPUS devices, the article number needs to have the text UTS, UTM or UTL included.
Please note that the device software for these devices is not included in the OPUS Projektor.
Contact your vendor for information where to get the newest software for these devices.
To create an ISOBUS application, choose the according Panel type and activate the check
box Use ISOBUS Application.