Latching means: When a button is pressed and released, it toggles state and stays in the
toggled state until it is pressed again.
Like that a latching button resembles a light switch whereas a non-latching button
resembles a door-bell switch.
With this property this behavior can be enabled.
Default value: Disabled
Possible values: Enabled or Disabled
Pressed State
Switch between the release or pressed state of the button. This is important for having a
preview of the object and also for adding pressed/released objects for the button (see
above).
Note: If only one child is assigned to the button the other state will be shown as empty on
PC tool but on the device this one child will show permanently - button shadow should be
used to show button state in this scenario.
This property has no influence to runtime behavior.
Default value: Disabled
Possible values:
·
Enabled (button is in pressed state)
·
Disabled (button is in released state)
Pressed Object ID
Not used for this object type.
Released Object ID
Not used for this object type.
Toggle Background Image
With this property the usage of the Pressed Image and Released Image can be turned on
or off.
Pressed Image
The image set in this property will be used as the pressed image. By default, this will be set
to the standard push switch pressed image.
Released Image
The image set in this property will be used as the released image. By default, this will be
set to the standard push switch released image.
To Next Page
Loading...