Trango Systems, Inc. GigaPlus User Manual Rev 3.1 22
Mode Switch: The Mode switch operates as follows:
1) Hold for more than 2 seconds, but less than 6 seconds, the unit will:
a. The IP address will be reset to default to allow access in the event of a
forgotten password or IP address.
b. The CLI management passwords will be reset to default
c. The Web interface passwords will be reset to default.
d. The SNMP read/write/trap community strings will be set to defaults.
e. The CLI prompt will be reset.
2) Hold for more than 6 seconds: The unit will reset the system configuration to
the factory default, but NOT reset the items it (1) above. The unit WILL REBOOT
automatically.
RESET: Reboots IDU without disconnecting the power supply.
2x GigE ports: ETH1 and ETH2 ports are the main traffic and In-band Management (IBM)
ports. Both are RJ-45 10/100/1000BaseT auto-sensing GigE ports.
2x SFP Port: ETH3 and ETH4 SFP Ports support two additional native 1000BaseT or LC
fiber Ethernet connection for traffic and IBM. SFP modules are available to support
each as follows:
a. SFP-GigE-C – Copper RJ45 module to support 1000BaseT
b. SFP-GigE-S – Single Mode Fiber for long haul
c. SFP-GigE-M– Multimode Fiber for short haul
To Next Page
Loading...