Vaisala WINDCAP WMT700 Series - Page 190

Parameter Name Default
Value
Allowed Values Units Description
aout_map
0 0 =
aout1, wind
speed
aout 2, wind
direction
1 =
aout1, North-
South, x
component
aout 2, west-
east, y
component
2 =
aout1, wind
speed
aout2, wind
speed alarm
A digital output:
hi when wind
speed > aout2_o
Parameter for analog outputs
in road and rail tunnel
applications and crane
applications. The parameter
provides horizontal and
direction data.
autoPort
1 1 = COM1 port
2 = COM2 port
Serial port to which WMT700
sends automatic data
messages.
autoSend
0 0 = Automatic
messages
disabled 1 … 99
Automatic data message
number. Selects the data
message format for automatic
messages.
cal_date
Wind calibration date. This is a
read-only parameter.
com1_baudcom2_baud
4 0 = 300
1 = 1200
2 = 2400
3 = 4800
4 = 9600
5 = 19200
6 = 38400
7 = 57600
8 = 115200
Baud rates for serial ports
COM1 and COM2. Changes
take eect only after reset or
the RESET command. Note
that a low bit rate can aect
measurement timing, if
WMT700 cannot send the
data message before a new
measurement starts.
com1_data com2_data
8 7 = 7 data bits
8 = 8 data bits
Data bits for serial ports COM1
and COM2. Changes take
eect only after reset or the
RESET command.
com1_delaycom2_delay
20 0 … 10000 ms COM1 and COM2 Response
delay in milliseconds.
WMT700 User Guide M211095EN-H
188