1009
Model Code Page
67. Powered front axle Carraro
1. 10. 1999
8450--8950 670 1
Contents
General (Code no. 670)
Technical Data 2..................................................................
Special tools 3....................................................................
Description 4.....................................................................
Axle housing and mounting brackets (Code no. 671):
A. Removing front axle 1...........................................................
B. Changing bearing sleeves of central pivot bearings 1.................................
C. Fitting front axle 2...............................................................
Hubs (Code no. 672):
1. Recondit ioning hub reduction gear
A. Changing planetary gears/bearing rollers 1.........................................
B. Changing hub cassette seal and wheel bearings 2...................................
C. C hanging king pin bearings 4.....................................................
Drive shafts (Code no 673):
1. Changing drive shaft/seals/bearing bushing:
A. Changing inner oil seal and inner bearing bushing 1..................................
B. Changing outer oil seal and outer bear ing bushing 2.................................
Reconditioning differential/bevel pinion shaft (Code no. 674) :
A. Changing bevel pinion shaft cassette seal 1.........................................
B. Removing differential 1...........................................................
C. Removing bevel pinion shaft 2....................................................
D. Disassembling differential 4.......................................................
E. Assembling differential 4.........................................................
F. Adjusting position of bevel pinion shaft 5............................................
G. Adjusting bearing preload of bevel pinion shaft 6....................................
H. Fitting differential onto bracket 7...................................................
I.Adjustingtoothbacklashbetweenbevelpinionandcrownwheel
and adjusting preload of differential bearings 7.........................................
J. Fitting differential into axle housing 8...............................................
Reconditioning steering ram (Code no. 675):
A. Reconditioning steering ram 1....................................................
Adjustments (Code no. 676):
A. Adjusting toe---in 1..............................................................
B. Adjusting steering angle 1........................................................
To Next Page
Loading...
