543
Model
Code Page
15.04.1994 16000---8400 39
PTO EMERGENCY STOP, FITTING INSTR.
(3)
PTO emergency stop 32916400
--- With this mounting kit the PTO emergency stop
can be fitted also on earlier Mezzo tractors (stan-
dard on ACII, IV Mezzo tractors). At the same time,
the PTO switch is changed to the 3---position
switch and the new switch is fitted on the side pan-
el.
The PTO does not start any more when the engine
is started.
PTO stops when the plug is removed from the
socket. Also an electric stop switch can be con-
nected to the plug (switch is not delivered with the
mounting kit).
FITTING:
--- Disconnect the battery earth cable. Remove the
cab lever console side panel. Detach the longer
switch panel section on the console.
--- Disconnect connector S25 (3 pins) in the console
in front of the PTO lever and connect inplace con-
nector ”S25” in the wiring loom 12.
Detach the switch in the PTO lever knob and re-
move it together with its wires. Place plug 11 in-
place of the switch.
--- Drill a ø 5,5 mm through the vertical gutter under
the panel. Fasten to the hole wiring loom 12 relay
holder with screw 1,2 and fit relay 10.
--- Ro c k in g s w i t c h 3 is fitted on the AUTOCONTROL
---panel (see picture). If there is already extra
switches on the panel (e.g. rear window wiper). fit
the new switch onto a free reserve place. Other-
wise, make on the panel 49x78 mm opening for a
switch frame 4 (place for opening has been
marked on the rear face of the panel). Place cover
plates 5 onto the other openings.
---Makea ø19mmholeontheRHsideofthelower
rear window above the PTO cable. Fit into the hole
emergency socket 6 (wire no 35 (lilac) to the
middlepinandwireno25(yellow)totheouterpin)
and fit the emergency plug fixing plate 7.
Fasten sticker 8 beside the hole. Fit the plug 9 into
the socket, plug fastener is fitted to the hole on the
plate.
--- Connect the battery earth cable.
Check the function of the emergency stop. How to
use the emergency stop, see the following page.
To Next Page
Loading...
