382
Model Code Page
34. Autocontrol ---III
15. 6. 1992
6100E, 8100E
343 2
Alternative parameter files
Model Transmission Language Parameter file name
6600E 420GL 40 km/h Finnish AC01086M.44S
Swedish AC01086M.44R
English AC01086M.44E
6600EH 420GL 40 km/h Finnish AC01046H.44S
Swedish AC01046H.44R
English AC01046H.44E
8100E 420GL 40 km/h Finnish AC01095M.64S
Swedish AC01095M.64R
English AC01095M.64E
8100E 420GL 30 km/h Finnish AC01105M.63S
Swedish AC01105M.63R
English AC01105M.63E
Copying parameter file into AC---III
unit
In this instruction the Program is in the hard disk (C:). If it is in
the floppy disk drive, use a correct prompt (e.g. A:)
J Connect the PC with the cable to the socket X10C.
J Switch on current to a tractor and to the PC.
JWhenpromptC:\> appears, type AC (ACC if colour
monitor) and press ENTER.
J A trouble shooting chart appears onto the PC display. In
the LH side lower corner of the chart there is the following
menu:
1PARAMETERS 5SENSOR LOG.
J Press F1 and the following text appears:
TRACTOR MODEL PARAMETERS
File name:____________________
J Type after colon a correct parameter file name.
JPressENTER
J Message PROGRAMMING AC ---III appears onto the PC
display. Programming in action.
J When the programming is successfully completed, text
AC III PROGRAMMED appears in the message window in
the RH side lower corner. During successful programming the
A C --- I I I d i s p l a y s w i t c h o f f a n d o n .
Note! Service Program error messages, see next page.
J To the disk operating system is returned by pressing the
function key F10 (EXIT).
The Service Program chart (on PC display) has the following
information:
Parameter table no = parameter file order no
Date of production = manufacturing date of ECS
PROM Checksum = program version
EPLD Version = program version of logic circuit
If the central processing unit (ECS) or the parameter file is
changed, write on the ECS sticker no 32666800 tractor serial
number, date and parameter file name after text SW.NO. Fix
the sticker onto the ECS.
To Next Page
Loading...
