EasyManua.ls Logo

Valtra 6550 - Gearbox Oil Pressure; Switch S44 for Blocked Pressure Filter; Gearbox Oil Temperatute Switch S16; Parking Brake Warning Light Switch

Valtra 6550
1361 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
114
Model Code Page
33. Agroline ---instrument
1. 9. 2002
333
106200--8950Hi
H. Gearbox oil pressure S17 (for warning light)
The warning light comes on, when the pr essure is too low
(20---50 kPa).
The sensor is placed on the servo valve block on the LH
side of the gearbox:
Mezzo/Mega HiTech
--- Mezzo/Mega: the sensor S17 is located on the upper
face of the valve block.
--- HiTech: the sensor S17 is located on the lower face eof
the valve block.
I. Gearbox oil temperatute switch S16 (for
warning light)
Mezzo/Mega HiTech
Position of switches:
--- Mezzo/Mega: on the front face of the valve block
--- HiTech: on the outer face of the valve block
Note! The switch illuminates t he warning light in the dash-
board, when the gearbox oil temperature rises too much
e.g. 90---96 ˚C. Also the STOP--- light starts to flash. Then
stop the tractor and try to find out the fault.
The engaging temperature tolerance of the warning light
sensor S16 is 93
˚C ±4 ˚C.
Due to manufacturing tolerances o f the sensor B3 for in -
strument display, the display value can deviate a bit
from
this
before the warning light of the sensor S16 comes on
If the temperature is continuously over 90 °C, clean the ra-
diator and check the gearbox oil level.
Note! Too high oil level in the gearbox c an cause overheat-
ing at high driving speeds.
J. Switch S44 for blocked pressure filter
(for warning light)
The switch (1) is placed in the pressure filter bracket. If the
tractor has many pressure filters/return filters (on HiTech---
models three), all filters have switch S44,seepage
910/9B. If only one filter is blocked the warning light comes
on.
K. Parking brake warning light switch
S52 (for STOP ---light and warning light)
H i Te c h --- m o d e l s :
There is a switch S52 placed in the front end of t he parking
brake hydraulic cylinder. The switc h activates the STOP---
light, if e.g. the parking brake cable is damaged or its ad-
justment is incorrect, see page 521/3.
In addition, there is a warning light in the dashboard, which
comes on when the shuttle lever is in P---position.
Mezzo/Mega---models:
There is a switch S15 in the rear end of the parking brake
lever on the LH side of the seat. The switch activates the
warning light, when the lever is pulled up.

Table of Contents

Related product manuals