856
Model Code Page
46. Front PTO
1. 8. 2000
6250Hi--
6850Hi
463 13A
I. Front PTO on 6250Hi ---6850Hi
1
Picture 23. Front PTO on 6250Hi---6850Hi.
The front PTO control unit (1) is placed in the switch console
and there is a separ ate adjusting knob to adjust the PTO en-
gaging time.
The PTO is engaged/disengaged with switch S38. In the front
PTO unit t here is a proportional valve Y9.
Note! The max allowed (continuous) loading in the engine
crankshaft is 400 Nm, which corresponds to an output of 87
kW (116 hp) in the PTO shaft at an engine speed of 2080 r/min
(PTO speed 1000 r/min. This must be observed, when large
implements are attached to the front PTO. Use a torque limit-
ing clutch, if necessary. With the torque limiting clutch the
max. torque can reach up to 830 Nm.
Maintenance
--- Oil quantity in the front PTO is 2,6 litres
---OilqualityShellDonaxTX
--- Change oil and clean suction filter at every 500 running
hours.
To Next Page
Loading...
