Valtra 6550 - Lower Row Shows; Upper Row Shows; Zeroing Distance Travelled; Setting Time

107
1. 9. 2002
333 3
6200--8950Hi
Model Code Page
33. Agroline ---instrument
1 . A g r o l i n e --- i n s t r u m e n t L C D --- d i s p l a y
The display (17) can monitor the following functionst:
Upper row shows:
(the function can be changed by pressing the RH side edge
of the switch 30):
--- distanc e travelled (m, km or miles) (max. 999 km)
--- r e a r P T O r e v s ( R ) ( r / m i n )
--- front PTO revs, option (F) (r/min)
--- t i m e
--- gearbox oil temp. (in display LO, when temperature below
+40˚C).
--- position of lower links (0--- 100) AC.
--- SigmaPower % (8950Hi only). Shows in percent how much
power is transmitted via rear PTO.
--- f a u l t c o d e s
--- Service interval indication
Lower row shows:
(the lower row has two functions and cannot be affected with
switch (30)):
--- running hours (visible, when the ignition is on and the en-
gine is not running)
--- driving speed (km/h or miles/h) (visible when the ignition is
on and the tractor is moving). When the speed is below 3
km/h,symbolL is visible.
When the ignition is switched on, the lower row shows first the
running hours and in the upper row there is the functio n which
was selected before the ignition was switched off.
Zeroing distance travelled
:
--- select the “distance travelled” to the upper row by pres-
sing the right edge of the switch (30).
--- press the switch (30)leftedgeaslongasthedistance
value is zeroed.
Setting time:
Do not pause for over 10 sec. while setting, because the
display is then switched into the normal mode.
--- Switch on ignition. Select the time in the upper row by
pressing the right edge of switch (30).
--- press the right edge for about 3sec., then the minutes
start to flash.
--- set minutes by pressing the switch (30)leftedge
--- select hours in the display by pressing the switch (30)
right edge
--- set hours by pressing the switch (30) left edge.
--- time is now set and the display is switched to the normal
mode after 10 seconds or by pressing the right edge of
switch (30) for over 3seconds.