1038
Model Code Page
67. Powered front axle Carraro
1. 10. 1999
8450--8950 675 2
1. Wear ring
2. Scraper ring
3. Oil seal
4. Cylinder liner
5. End flange
6. Oil seal
7. Scraper ring
8. End flange o---ring
9. Wear ring
10. Piston seal
11. Piston seal expansion ring
12. Piston rod and piston
7. Remove the wear rings, the piston seal and o---rings, end
flange seals and oil and scraper rings.
8. W ash the parts with suitable solvent and let them dry.
9. Chec k the piston rod. Small damages can be repaired
with fine emery cloth.
Oil hose
10. Refit the assembled steering ram onto the differential
bracket .
Piston rod
Fixing bolts
Flange
Oil hose
11. Tighten the fixing bolts to a correct torque (120 Nm). Re-
connect oil hoses.
12. Reconnect the tie rod ball joint (300 Nm, locking nut 250
Nm). Reconnect the tie rod to the steering arm (220 Nm).
13. Add drained oil into the system. Start the engine and turn
the steering wheel from one extreme position to another many
times and ensure that the steering system functions properly
and that no leaks exist. Check, if necessary toe---in .
To Next Page
Loading...
