1048
Model
Code Page
14.03.2000 6000---8750
69.3
2
REVERSE DRIVE CONTROL, fitting instruction
(22)
27.11.1996
(not HiTech)
1. Preliminary works:
--- Disconnect the battery earth cable.
--- Remove the seat and the floor mat.
Remove the side panel protection, the hand
brake console, the passenger’s seat and the tool
box.
---Removethewireloominsidetherearbeamand
tie t he loom to the protective arch.
--- Remove the lower window at the rear of the trac-
tor.
Remove the electric socket and the PTO safety
switch from the loom (these parts must be
reconnected).
This ensures that the wire loom does not dam-
age while drilling holes to the beam.
--- Mark a ø 9mm starting hole according to the
picture.
Fasten the housing to this hole and mark other
holes which are to be drilled. Drill ø 9mm holes
with a drilling machine.
Mark and drill also holes a and b for the rear
steering wheel.
--- Remove a bit from the edge of the hole for the
brake pedal
--- Paint all points where is not the original paint.
--- Pass the clutch cable under the cab.
2. Fitting accelerator pedal:
--- Fit t he pedal bracket and mark places for the
holes (3x). The relief on the bracket must
become against the protective rubber of the
hand brake lever cable. Drill ø 9mm holes.
Drill with a self---tapping screw a fastening point
for t he return spring in the rear beam (see pic-
ture).
--- Fasten the pedal and check function.
Note! Fasten the clutch cable + fast ening eye
under the rear fixing bolt of the accelerator
pedal.
--- Remove the accelerator pedal in the front part of
the cab.
Fit in place a pre---assembled pedal. Secure it
with a tension pin.
--- Fit t h e c a b le
(32496800) between pedals. Check
that the cables to the front pedal are in the
straight line, so t hat there are not curves, which
can prevent the function of the pedals. If necess-
ary, bend the cable support on the floor.
(From cab no ca 15575 the piece 32602400 is
not needed).
To Next Page
Loading...
