1051
Model
Code Page
14.03.2000 6000---8750
69.3
5
REVERSE DRIVE CONTROL, fitting instruction
(22)
27.11.1996
(not HiTech)
--- Adjusting the accelerator pedal cable:
Remove play from the rear fixing nuts of the
cable.
Adjust the limiter screw of the rear pedal bracket
so that the pedal touches the floor mat when it is
depressed.
Make the adjustment with the cable front nuts so
that both pedals move without play and simulta-
neously.
--- Cut holes to the hand brake protection for the
accelerator pedal (see picture 2a). If it is fitted
also the reverse drive controls, the protection
must also be shortened.
Tighten the sheet metal protection (32600910)
with silicone and fit it. Fasten the hand brake
protection.
3. Fitting clutch pedal:
--- Dimension a starting point to the cab front wall
with a ø 4mm drill (see picture).
Cut to the insulation of the front wall an opening
of 100 x 250 mm (under the lever support).
Drill with a 45 mm hole drill a hole at the starting
point h ole.
--- Remove the clutch pedal power assistance.
Note! a locking pin into the hole before removing
the spring assembly!
--- Earlier model: Make M8 hole to the upper fixing
point of the power assistance (see picture) for
clewis 6 (picture 3a).
Latest models: fork (32633710) fastens to the
arm of the pedal.
--- Fasten the leverage to the clutch pedal (see pic-
ture 3a). Check that the lever is in the middle of
the hole (otherwise resulting malfunctions), Turn
the leverage carefully, if needed.
Mark places for holes of support 22 upper end
and make M6 t hreads.
Fasten the support upper end and mark places
for other holes, drill ø10mm hole.
--- Apply silicone mass round the fixing holes (for
water leaks), and fasten t he bracket of the
levers.
--- Fit t he leverage, the levers must not get
entangled.
Fit the power a ssistance.
To Next Page
Loading...
