1057
Model
Code Page
14.03.2000 6000---8750
69.3
11
REVERSE DRIVE CONTROL, fitting instruction
(22)
27.11.1996
(not HiTech)
6. Fitting steering hydraulics:
--- a s se m b le t h e b r a ck et + c h an g e --- ov e r v a l ve
under the priority valve. Because of the modifica-
tion of the priority valve (with effect from tractor
number F13208--->), the bracket s and fastening
are different, see pictures 6a and 6b.
--- Fasten the hoses (starting from the rear ends)
according to pictures 5 and 6. Fasten the hoses
together with plastic clips.
The hoses are drawn under the cab floor behind
the shuttle lever to the priority valve.
6b. Fitting steering hydraulics (reverse drive con-
trol +directional control valve):
--- Fasten the directional control valve under the
fixingboltoftheLHsiderearaxlehousing.The
fixing point depends on the tractor model (see
picture 6b).
Fasten the hoses according to the picture.
--- C o n n e ct w ir e l o om
(32876000) connector t o the
directional control valve.
Pass the loom through the hand brake cable
hole into the cab.
Find connector X49 near the seat (red and white
wires), and connect to the wire loom.
In the loom, there is a reserved connector for the
pneumatic seat.
7. Rest of fittings:
--- Fasten gaskets to the edges of the rear housing
(see picture 4) and place (plexi)glasses into the
housing (screw + w a sher + rubber plate).
--- Fit the rear mirror, see picture 7.
--- Refit the cab floor ma. Mount the towing hook
releasing control.
Refit the seat.
--- Glue warning stickers (32843800 and 33332700)
onthebeamintheloweredgeoftherearwin-
dow.
--- Replace the stickers on the earlier rear window
to the new window.
To Next Page
Loading...
