1081
Model
No Page
24.02.1999 969.5
FRONT AXLE AIR SUSPENSION, fitting instr.
(17)
6900(8000R)
8050---8950
Fitting compressor (6900, 8000, 8000R, 8100, 8400,8050,
8150)
:pictureG
On 6---cyl. engines the compressor is alw ays fitted
ontheRHsideoftheengine.
---Removetheenginesideplates.Liftuptheengine
hood plate.
--- Fasten an extra belt pulley 35 on the ready---fitted
pulley(thesamefixingbolts).
Change alternator shield 38.
--- Fit the compressor bracket and the compressor
according to the picture at the bolts of the engine
timing gear casing.
One return oil hole in the compressor bottom is
plugged with plug 11. In the hole at the return hole
must be fitted an o---ring 10.
Fit the return pipe parts (13, 14, 27).
Change the alternator shield 38.
--- Remove the plug screw behind the alternator on
the cylinder block and fit in it the compressor lubri-
cating oil hose 25 one end (union 50). Fasten the
other end to the compressor.
--- Assemble the tightener (parts 39--- 48)intoplace.
Fit the belt 37 and tighten it.
NOTE! check:
--- alignment of the pulleys
--- belt tensioning
--- tightness of pipe connections
--- Replace the suction pipe intermediate pipe with
pipe 5, and fit the suction pipe 4 with its parts into
place. Fasten the suction pipe at suitable points.
Fitting compressor (8450---8750
):pictureH
--- Fitting like above shown.
The alternator shield is not changed.
Fitting the air reservoir (pictures I and I.1):
--- Fasten support 6 un d e r t w o g e ar b ox --- to --- fu e l
tank bolts (M16: 270---330Nm, M12: 125 Nm), see
picture I.
Holder 31 is fastened between foot step bracket
and intermediate frame support.
--- Fa s te n b r a ck e t 34 under the nuts of the foot step
front support.
--- Use the reservoir bracket 17 as a pattern and drill
holes (2 pcs, 6,2 mm) through the wall on the
footstepframeside(pictureI).
To Next Page
Loading...
