1159
Model
Code Page
1FITTING INSTRUCTION 03.08.1993 6000---8400 89
ELECTRIC AIR FILTER
(3)
Electric air filter 32675100
--- The electric air filter can filter also small particles
which cannot be filtered by mechanical filters (the
electirc air filter can filters particles with sizes of 0,2
Nm).
The cabin air becomes more pleasant and the pro-
ductivity increases.
The filter consists of the paper filters and a dust
collection element of the high voltage type in which
the dust particles fasten on the metal plates. The
dust collection element is washable.
The air filter is fitted in place of the roof hatch. How-
ever, the roof hatch can be used as an emergency
exit even if the air filter is fitted on the tractor.
The filter increases the cab total height about 20
cm.
The fan has three different speeds.
The power consumption is max. 210W (The elec-
tric air filter : 10 W).
Ionizing voltage: 8000 V.
The filter is connected to fuse F26 (10A).
Fitting:
--- Remove the upper roof plate as follows:
Remove the roof hatch (hinges). Unscrew t he
screws on the edges of the roof hatch opening.
Unscrews the screws on the roof front and rear
edges. Uncrew the front gutter plate screws.
Remove the upper roof plate.
--- Open a little the cab linings at the cab side pillar so
that you can pass wire 20 into the connector ”A7”
and further to the roof side. Draw the wire to the LH
side front edge of the roof opening.
--- Refit the roof plate and fit the front gutter plate
screws and the middle screw of the roof front edge.
NOTE! Do not tighten the screw s too hard since
the roof material can damage.
--- Fi t w a sh e r s 19 (5 pcs) at the fastening holes. Fit
gasket 2 onto the bracket 9.
Fasten the bracket 9 onto the roof with new
screws. (front end screws M8 x 40). Detach the
roof hatch lock counter piece on the edge of the
hatch.
--- Fasten the fastener 10 and the counter piece 21
onto the roof.
--- Connect connectors SA1687 and connector plug
SA 1950 to the air filter current wire. Connections,
see picture C.