EasyManua.ls Logo

Valtra 6550 - Page 1233

Valtra 6550
1361 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1176
89.2
Model
No Page
AIR CONDITIONING, FIT TING INSTRUCTION
(PT94--- cabin) 30.07.1999
6 (28)
28.06.1999
6000---8750
6250Hi---8950Hi
Compressor (picture 3).
--- Carefully turn the radiator cap to the first stop so
that possible overpressure releases from the
engine cooling system before fitting the extra
belt pulley and the compressor.
--- Fit the compressor bracket opposite the s crews
oftheintakemanifoldaccordingtothefigure.
Change the screws into longer ones (HA8331).
Unscrew from the injection pump the fuel injec -
tion pipe for the first cylinder for easier work.
Models 6800, 6250H-- 6850Hi: fit the bracket to
the hindmost holes.
--- Fasten the compressor onto the bracket.
--- Fit hos e s 4 and 40A w it h o --- rin gs
(tightening torque for the hoses: see picture.
Models 6000-- 6600: Extra bel t pulley (picture 4)
--- Fit an extra belt pulley on the existing pulley.
Useanintermediatepiece58 and screws 59 (6
pcs).
--- Fit the idler wheel on the engine RH side oppo-
site the screws for the thermostat housing and
the engine lifting eye. Replace t hermostat screw s
into special screws 10 and 11 one screw at a
time for avoiding leaks. Fit support 8 and the
idler wheel. Fit the V---belt and tighten it to a suit-
able tension.
Models 6800-- 8750, 6250Hi-- 6850 Hi,
8050Hi--8950Hi: Compressor drive is taken
from the coolant pump v---belt pulley.
Up to engine number D1229:
Remove the coolant pump (drain engine cool-
ant). Unscrew the belt pulley securing nut and
remove the belt pulley. Use, if needed, puller
9052 48900. Change the belt pulley into
3---groove pulley (836855063). Remove the inter-
mediate piece (836847538).
From engine number D1230: T h e 3 --- groo v e b e l t
pulley is ready---mounted on the tractors.
Models 6000-- 6800, 6250Hi--6850 Hi: If the
tractor has an electric stop solenoid, an extra
idler pulley 95 should be fitted on the com-
pressor bracket.
Models 6000-- 6800, 6250Hi-- 6850 Hi: If the
trac-
tor is equipped with compressed air system
,the
aircompressorshouldbemovedtotheRHside
oftheengine(seeappendix1,onpage25).

Table of Contents

Related product manuals