1195
89.2
Model
No Page
(P T 94 --- cabin)
AIR CONDITIONING, FIT TING INSTRUCTION
30.07.1999
(28)
28.06.1999
25
6000---8750
6250Hi---8950Hi
APPENDIX 1
If the tractor (3, 4---cyl.) is equipped w ith
com-
pressed air system
, the air compressor should
be moved to the RH side of the engine:
--- In this case a vertical exhaust silencer and a
new engine hood plate should be fitted.
A cutting must be done on the wind tunnel (fan
comes more forward). At the crankshaft end,
there are three belt pulleys. The two outer
pulleys power the compressed air and air condi-
tioner compressor.
---Removetheenginehoodplateandtheverticalsi-
lencer. Remove the radiator cowl.
--- Make holes in the cowl according to picture.
--- Note! The compressor bracket of the air condition-
ing must be fitted in the rear holes.
Fasten the compressor extra support 20.
--- Change an extra belt pulley 35 i n p l a c e of on e ---
groove pulley (without intermediate piece).
--- Fit the compressor bracket and compressor ac-
cording to picture at fixing bolts of the engine gear
wheel casing. Fit the return pipe parts (13,14,27)
into place
Change the alternator protective covering 38.
--- Remove a plug screw on the cylinder block behind
the alternator and connect into hole the com-
pressor lubricating oil hose 25 one end (union 50).
Fasten the other end to the compressor.
--- Assembly the tightener (parts 39--- 48)intoplace.
Fit the belt 37 and tighten it to a suitable tension
NOTE! check:
--- belt pulley position in relation to the other pulleys
(must be in the same line.)
--- b e l t t e nsion
--- Tightness of hose unions
--- Fit the vertical silencer 23p w ith its parts. Fit a new
engine hood plate.
To Next Page
Loading...
