1263
Model
No Page
99.56600---8750 1
RETURN OIL FILTER, fitting instruction
6000---8000
(2)
22.06.1999
06.08.1999
Fitting serie (6000---6400,6900,8000) 33774000...
Fitting serie
(6600,6800,8050---8750) 33766700
--- The return oilfilter filters return oilfrom the a uxiliary
hydraulics.
In connection with oil change is recommended
that new oil is poured in through the return oil filter
for t he auxiliary hydraulics.
FITTING:
--- From ser. no. F16407 incl:
Remove the low pressure circuit filter and its sup-
port plate.
--- All tractors: Fasten a new support plate 62 under
the bolt of the final drives, see picture (tightening
torque (8.8): 80 Nm, (10.9):125 Nm).
Move the leak oil support to the left side of the trac -
tor (picture B), and shape it if needed. Check that
the oil reservoir don’t touch the power lift linkage.
NOTE! Replace on models 6000---6400, 6900,
8000 (smaller final drives) the support fixing bolts
with 10 mm longer ones (ref. 4).
--- Refit the low pressure filter +sleeves 61 and a new
return oil filter 15 (compl.) on the support plate.
If the tractor has not the low pressure filter, fit the
return oil filter to the foremost holes of the support.
The lower edge of the cab (picture A) may touch
the filter cover (NB! the flexibility of the cab).
Grind the lower edge when needed, paint the
grounded points.
--- Connect the outlet and inlet unions of the return oil
filter.
--- Fasten the extension pipe 1 of the return oil con-
nection.
--- Drill a 23 mm hole through the support plate for
the quick coupling (see picture). Fasten quick
coupling 21A on the support.
--- Connect the pressure hoses and fit t hey so that
they do not touch the cab or lifting lever.
--- Check the function of the fitting.
NOTE! Do not use any more the old return oil con-
nection, since then the return oil does not circulate
via the filter.
To Next Page
Loading...
