Valtra 6550 - Page 558

159
Model Code Page
37. Autocontrol 5.2 (K41107---)
1. 9. 2002
371 6C
6250--8950
1. 8. 2000
Main program version 83.
Can be fitted from K41107 --->
These can be replaced with program version 86
.
ThesemustnomorebeusedinService.
11 83
4)
6250Hi ---6850Hi, X100---X120
21 83
4)
6250Hi --- 6850Hi HiTrol
31 83
4)
8050Hi ---8150Hi
41 83
4)
8350Hi
51 83
4)
8450Hi ---8950Hi
Main program version 83 (parameter files changed).
Can be fitted from K41107 --->
These can be replaced with program version 86
.
ThesemustnomorebeusedinService.
16 83
4)
6250Hi ---6850Hi, X100---X120
26 83
4)
6250Hi --- 6850Hi HiTrol
36 83
4)
8050Hi ---8150Hi
46 83
4)
8350Hi
56 83
4)
8450Hi ---8950Hi
Main program version 84.
Can be fitted from K41107 --->
These can be replaced with program version 86
.
ThesemustnomorebeusedinService.
16 84
4)
6250Hi ---6850Hi, X100---X120
26 84
4)
6250Hi --- 6850Hi HiTrol
66 84
4)
6750Hi
36 84
4)
8050Hi ---8150Hi
46 84
4)
8350Hi
56 84
4)
8450Hi ---8950Hi
Main program version 85 (Is not fitted in production).
Can be fitted from K41107 --->
These can be replaced with program version 86
.
ThesemustnomorebeusedinService.
16 85
4)
6250Hi ---6850Hi, X100---X120
26 85
4)
6250Hi --- 6850Hi HiTrol
66 85
4)
6750Hi
36 85
4)
8050Hi ---8150Hi
46 85
4)
8350Hi
56 85
4)
8450Hi ---8950Hi
4) If the clutch pedal has malfunctions or the tractor has
malfunctions (e. g. fault codes P101...P109), the trans-
mission has jammed or if tractors transmission has not
disengaged complety with clutch pedal, with HiShift
button or with shuttle lever, then must a new program
be input (main program version 86 and parameter file).
Programming instructions on page 370---24B.
A new program must be input in the control unit (main
program version 86). In version 86.
the fault s which are
found in versions 80---85, have been corrected and the
function has been improved.
Main program version 86.
Can be fitted from K41107 --->
Thesemustbeusedinservice
.
These programs are in disk 344 046 20.
17 86 6250Hi ---6850Hi, X100---X120
27 86 6250Hi ---6850Hi HiTrol
67 86 6750Hi
37 86 8050Hi ---8150Hi
47 86 8350Hi
57 86 8450Hi ---8950Hi
InServiceandInSparePartscanbeusedonlythenewest
programs (version 86).
NOTE! After loading the main program file to a control unit, the
corresponding parameter file must be loaded from the same
diskette as the main program file and it must corr espond with
the tractor model.
Note! If in the test mode FII the I.D. number is 9986
after programming or after co ntrol unit change, the
parameter file has not been input. Input correct para-
meter file according to instr. on page 370---24B.