Valtra 6550 - Page 602

553
Model
Code Page
1
6600,8100
20.06.1994 39
DPS---CONTROL UNIT +SIGNAL LIGHTS, FITTING
(3)
8400
--- Del ta Power Shift-- control unit 32949000..
(the unit is a standard equipment on DPS tractors
from ser. no 662343--- > ( A C I I ) .
--- D e lt a Po w e rs h i f t --- con t r ol u n i t f a c il it a t e s t h e u s e o f
the extra buttons to control the DPS.
(control of the DPS solenoid valves happens via
the control unit and not direct.
The mounting kit incl. also the DPS signal light
panel+buzzer (gives a sound if the engine is
stopped without applying the hand brake).
FITTING:
--- Disconnect the battery earth lead.
Bend the floor mat at the controllevers and remove
the linings in the lower part of the levers.
Disconnect the connectors of wires into the speed
gear lever and remove the earlier wire+rocker
switch from the lever knob.
Remove the speed gear lever knob.
--- Place the lens 20 onto the knob 19. Fit the wire
loom 15 push buttons 17 into the frame 18. (order:
the red wire rearmost, the connectors one on the
other) and fit them into the knob 19.Passthewire
loom through the lever. Fit the knob, be careful not
to damage the wires.
Connect the wire loom lower end connectors to the
connector ”S23” half 16 (is delivered with wiring
loom 8, order: see figure).
--- Fasten the control unit 13 under the bolts of the
gear lever bracket.
--- Connect the control unit connector ”A10” to the
corresponding connector in the wiring loom 8.
Connect the connector X30 to the corresponding
connector in the wiring loom 8 (wire no 4, yellow).
Connect connector ”X23” to the corresponding
connector in the wiring loom 8.
Connect the push button connector ”S23” to the
corresponding connector in the wiring loom 8.
(Possible extra push buttons are connected to the
connector ”S23: ”).
--- Detach the dashboard upper panel. Cut off the
neck between two holes for extra switches in the
RH side upper corner of the panel.
Remove the protective cover behind the fuse box.
---Passthewireloom8 connectors A9, X21, and wire
no 167 along the floor cable flute into the steering
wheel console. Fix the wire loom with tape in suit-
able points.