Valtra 6550 - Page 904

851
Model Code Page
46. Front PTO
1. 8. 2000
6000--8150 463 9
1. 4. 1997
2. Repair instructions, front
PTO on 6000-- 8150
A. Maintenanc e (also 8350---8950)
1. All front PTO fixing bolts should be retightened after the
first 100 running hours.
2. Check occasionally for leaks, change leaking parts.
3. 8350---8950: grease the drive shaft universal joints
nipples at intervals of 50 0 running hours.
4. 6000---8150: Change oil and filter at intervals of 500 run-
ning hours (clean the filter on 6250---6850, Kxxxxx---).
8350---8950: Check oil level at intervals of 500 running
hours, top up if needed.
Oil amount and oil qualit y:
--- 6000---8150: 4 litres SAE 10W/30 GL4 oil.
--- 6250Hi---6850Hi: 2,6 litres, Shell Donax TX.
--- 8350---8950: 2,5 litres SAE90 oil, Shell Tivela WB.
Draining/level plugs:
--- 6000---8150, see picture 13 on page 463/3
--- 8350---8950, see the next picture
--- 6250Hi---6850Hi, see page 463/13B.
5. When necessary, clean the oil cooler to prevent overheat-
ing of the front PTO.
6. At every 500 running hours, c heck the rubber coupling
for breakage or tears and replace if necessary.
Oil level
Draining
(pipe)
Draining
(pipe)