Authorization Code Table (PGM 227) 1-123
Chapter 1: SBX IP Online PC Admin
SBX IP - PC Admin Guide
Authorization Code Table ( PGM 227)
Trunk groups can be marked to deny access until a matched Authorization code is entered. In
this case, a DND warning tone is provided when the trunk group access code is dialed. If the
dialed Authorization code is verified, you will receive CO dial tone. Otherwise, you will receive
an error tone and you cannot access the group. Stations or admin programming can enter the
authorization codes. An Authorization code is fixed at 5 digits. The Administrator can see and
change a station's password. There can be no duplicate entries. By default, Authorization
Codes are not assigned.
Operation
1. Click [Authorization Code Table]. If an authorization code is already registered it will
be shown.
2. After editing, press the [Update] button to save changes.
You can save and reload these codes as a file. If you want to save or reload database file,
click the update menu and select a menu.
• [Auth Code Data Save]: Save the data as a file.
• [Auth Code Data Load]: Load the data as a file.
• [Auth Code Data Save]: Write loaded data to the MPB from start to end automatically.
At this time, you do not need to do anything. PC Admin will operate the process
automatically until an empty bin is found.
The file that is used by this feature cannot be opened or edited by other software. This file
is specific to PC Admin.
Auth code range was from 3 digits to 11 digits and COS will be displayed. From index 1 to
maximum station number, Day / Night COS will be displayed and you cannot change
them. But the other range of index, you can change the COS.
If you want to change the COS for a station number, you should program PGM 116.
To Next Page
Loading...
