SIP Attributes 1 & 2 1-147
Chapter 1: SBX IP Online PC Admin
SBX IP - PC Admin Guide
Operation
1. Select the VOIB board number. If the selected board number is not the VOIB, PC
Admin will display an error message. This program is valid only for VOIB.
2. After the selecting board number, press the [Refresh] button. Then PC Admin will
receive the information about the selected VOIB.
3. Upon initial entry, all data are default values. Ask your network administrator for
correct values.
4. To save the data, press the [Update] button.
Note:
SIP Attributes 1 & 2 are also opened from this window. There is no PGM code for SIP Attributes.
So, you cannot program SIP Attributes with a keyset.
SI P Attributes 1 & 2
You can program SIP Attributes. These features are not included as a keyset Admin item. So,
if you want to change SIP Attributes, you should use the latest version of PC Admin software.
Operation
1. Enter the PGM 340/341 area of programming.
2. Click on the [SIP Attr 1] button.
3. Either enter appropriate entries in the following fields or leave them empty:
• Proxy Server Address can be assigned text data or an IP address. Maximum length of
this field is 32 characters. You should enter the proxy server address if you are using a
proxy server in your SIP application.
• Proxy port can be assigned from 0-9999.
• Registration timer is available from 0-65535.
• A primary and secondary DNS address can be entered the same as the proxy server
address. You can enter IP address or text up to 32 characters.
To Next Page
Loading...
